Glow in the Dark, Photo Luminescent Sticker Film and board are PVC sheets with glow material applied on them. Glow sticker film and board are two different products. Glow film is made from soft PVC and is flexible and can be cut easily into any required shape, either with a pair of scissors or by die cutting. Glow Stickers come with adhesive backing. Glow board is made from hard PVC and is a rigid and non flexible.

These luminous products come with or without a layer of transparent PET protective sheet. The purpose of this PET sheet is to provide additional protection to the glow surface. The PET layer must be removed if you intend to do any sort of printing on this material. Silk Screen Printing and Laser Printing are the only direct printing methods suitable for this product. InkJet Printing is also possible with special modifications to the surface.

You can also choose between adhesive and non adhesive backing. Adhesive backing enables the film or board to be stuck on any normal, flat surface, free from oil or grease. While this product can be used outdoors (product code PLFGH-100. See below for details), the adhesive is not strong enough for outdoor use.

This product is a finished product and can be used to create glow signs, designs (by indirect printing), labels, or route markers in emergency situations.

This product comes in 4 grades.

Super High Glow (over 16 hours), High Glow (up to 12 hours), Mid Glow (up to 8 hours) and Low Glow (up to 2 hours). The table below shows the difference in the grades.

Photo taken in normal light Photo taken within 1 minute Photo taken after 30 minutes

Glow in the Dark Signs

Ready made Signs

Ready made Letters and Numbers that Glow in the Dark

Custom made Glow in the Dark Design and Print

FAQ

Catalogue

Glow Color Chart

Contact us

Glow in the dark products

UV Lighting
c/w Casing and Bulbs

Glow Discussion Forum